Sharp IV-C35M User Manual page 36

Setting and Operating Outline
1
*3 Set the measurement
start input to any choice
other than "parallel" or
set the 'READY' ON
signal to "end
measurement."
- When the stop NG measurement option is set to "YES" (page 3-53), the controller stops measuring
when an error occurs.
From the previous page
Determining the measuring time (timer stop)
Parallel output (Y0 to Y15) OFF
External interface enabled (communications)
No
Serial output
General purpose serial output
External interface enabled (key, parallel)
No
Yes
READY ON
Waiting for a measurement start input signal or a key input
Computer link
General purpose
Computer link output
*3
1-28