Setting The Measurement Programs - Sharp IV-C35M User Manual

1-4 Setting the measurement programs

To execute a specific measurement program (positional deviation measurement, degree of match
inspection, etc.), select MEASUREMENT 0 to 4 on the "MEA-CND" line.
- MEASUREMENT 0 only allows you to measure positional deviation.
- For details about the settings for each measurement program, see Chapters 4 to 17.
- Specify the conditions for distance and angle measurement in the positional deviation measurement,
the degree of match inspection, object identification by binary conversion (MEAS GRAV CENTR:
YES), multiple position measurement, and for multiple degree of match inspection.
(1) Operation main screen (see page 1-10).
TYPE00
MEAS 0000ms 2001-10-14 10:38
MEASURE 0 CAM1 NO
X0~7 Y0~7
MNU-CHG MAIN-COND CHG-MEA COND-CHG CHGN-REG SCREEN-CHG CHGTYPE
Move the cursor to the "MAIN COND" item using
the left and right arrow keys and press the SET key.
(2) Select the "OBJECT TYPE COND" using the up
and down arrow keys and press the SET key.
(3) Move the cursor to the "TYPE(NEW)" item on the
"OBJECT TYPE COND" line and press the SET
key.
(4) Move the cursor to "TYPE00" on the "SELECT OBJECT TYPE COND" line and press the SET key.
To select "TYPE01" and others, move the cursor to "TYPE(NEW)" and press the SET key.
(5) Select "MEAS0 to 4" (MEAS0 is only used for positional deviation measurements) on the "MEAS
COND (CAM1)" line and a popup menu will appear. Select any desired measurement program from
this popup menu and then press the SET key.
COLOR F C1 BRT
V*.**
READY
1-13
Setting and Operating Outline
MAIN MENU
IVC35M
SYS-CND
OBJECT TYPE COND
SET WIZARD
EDIT MAIN OPS MENU
OPTION
ENVIRONMENT SETTING
MEMORY CARD
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE(NEW)
1
COLOR F C1 BRT
COLOR F C1 BRT