Sharp IV-C35M User Manual page 29

Display when an NG image is captured
The controller automatically refreshes the NG image each time a new NG image is captured.
[An example of the split screen display (above and below)]
Measured
image from
Camera 1
NG image
from
Camera 1
Camera 1
OK1 NG2
capturing
image
Camera 1
NG image
Display history of NG images
Move the cursor to the menu bar "SCREEN-CHG" on the operation main screen, using the left and right
key. Select the "NG-IMG-DISP" from the popup menu to display previous NG images.
[An example of scrolling the split screen display (above and below)]
Display NG
image
history
NG image number 9
When a new NG image is captured while displaying the history, it will be added to the history.
Note
- When "PARTIAL-IMG" is selected for image capturing (page 2-4), the NG images stored
have the maximum rectangular area set in measurements 0 to 4.
- When "CAM1&NG-IMG" is selected for the monitor output, only one camera* can be used
for each measurement (0 to 4) and for image pre-processing.
* The camera connected to the camera 1 connector (CAMERA 1).
OK4 image
NG2 image
OK3 OK4 OK5
NG2
Measured
image from
camera 1
Up key
Down key
NG image number 10
- When a maximum of 10 NG images is registered.
1-21
Setting and Operating Outline
NG6 image
Refreshes to NG6 image
NG6 OK7 OK8
NG6
Up key
Down key
NG image number 0
1
OK7 image
OK9