Sharp IV-C35M User Manual page 68

Setting Measurement Conditions
Setting procedures
1. On the menu tree, select "MAIN MENU" ->
"OBJECT TYPE COND" -> "TYPE00" ->
"MEA-CND(CAMERA1)" -> "MEAS(NEW)," in
that order. Then, press the SET key.
3
2. Select "
key. On the popup menu, select "COLOR
FILTER" and press the SET key.
3. Select "
SET key and open the sub-menu. On the sub-
menu, select "
select filter type from the popup menu.
* In this example, select "RED" (red filter).
RED
GREEN
BLUE
BRIGHT LEV
ANY
COLOR MODE" and press the SET
COLOR FILTER SET" and press the
FILTER TYPE," and then
Displays red areas more brightly.
Displays green areas more brightly.
Displays blue areas more brightly.
Displays areas that are within the specified brightness range (within the specified
upper and lower limits) more brightly.
Specify the optimum color filter parameters to use, based on the original image
conditions.
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS0
POSI-CORRECT
MEAS(NEW)
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/0
OBJ-TYPE SYS.
TYPE(NEW)
=NEW REGISTRATION ESC=BACK SEL=CHNG IMG TRG=POPUP
MEASUREMENT1 SCREEN COND SAVE
1COLOR MODE
COLOR FILTER
2COLOR FILTER SET
(TO NEXT SUB-MENU)
3MEAS SELECTION
NO
MEASUREMENT1 SCREEN COND SAVE
1FILTER TYPE
3-6
1
2
3
RED F C1 BRT
COLOR FILTER
EXTRACT COLOR
RED F C1 BRT
RED
RED *
GREEN
BLUE
BRIGHT LEV
ANY