Setting The Register Conditions For Edge Detection - Sharp IV-C35M User Manual

Setting the Input/Output Conditions
Setting the register conditions for edge
detection
SEARCH AREA
Select "
the SET key to go to the setting screen.
DTECT MODE
Select an image processing method for the
edges.
SEARCH DIR
Specify a search direction.
For details, see page 3-25.
THRESHOLD
Specify a threshold value for binary
conversion.
For details, see page 3-21.
Light level
Automatic setting
Select "AUTO-REG" from the upper function menu on the THRESHOLD setting screen. The
controller will set the optimum value automatically.
REF COORD (reference coordinates)
You can change the reference coordinates to any desired position.
SCALE
Enter the actual value of the distance between coordinates 1 and 2. In this example, the distance
is 10 mm. Therefore, enter "10."
SCALE (UNIT)
Select unit of distance between coordinates 1 and 2. In this example, select "mm."
REG (register)
While the cursor is on "EXEC" (execute) press the SET key again. The controller will be
calibrated to treat 1 pixel = 1 mm.
21
SEARCH AREA (MDL0)" and press
Flat
Edge
width width
Density difference
CALIBRATION SCREEN COND SAVE DATAIL
1SEARCH AREA(MDL0)
2DTECT MODE(MDL0)
3SEARCH DIR(MDL0)
4THRESHOLD(MDL0)
5REF COORD(MDL0)
6SEARCH AREA(MDL1)
7DTECT MODE(MDL1)
8SEARCH DIR(MDL1)
9THRESHOLD(MDL1)
0REF COORD(MDL1)
qSCALE
wSCALE(UNIT)
e
SET=WINDOW SET ESC=BACK SEL=CHNG IMG TRG=POPUP
21-32
RED F C1 BRT
SET(224,208) (287,271)
CHNG POINT
CHNG POINT
HORIZ( )
DRK BRT
SET(D:050 E:2 F:04)
BRT DRK
SET KEY(256.240)
CENT(BRT)
CENT(DRK)
SET(224,208) (287,271)
CHNG POINT
HORIZ
HORIZ( )
HORIZ
SET(D:050 E:2 F:04)
VERT
SET KEY(256.240)
VERT
000.00
mm
CBP 000.0000 mm
CBM 000.0000 PIXEL