Setting Procedure - Sharp IV-C35M User Manual

(2) Operation setting details
Select the "POSI-CORRECT" condition item on the
"SELECT OBJECT TYPE COND" screen and
press the SET key to enter the correction.

Setting procedure

No
Mode 0
No
Mode 1
(3) Correction example
Example of correcting the first X and Y point
1. Amount of correction (X2-X1, Y2-Y1) specified by measurement 0 (positional deviation
measurement)
Coordinates (X1, Y1) of object in the reference image (model 0)
X2-X1
2. Measuring a point using measurement 1
X2-X1
XY ADJ.
- X CORRECTION (no/yes)
- Y CORRECTION (no/yes)
XY ADJ.
- X CORRECTION (no/yes)
- Y CORRECTION (no/yes)
Target object coordinates (X2, Y2)
[Measurement results]
- Detected coordinates: (X2, Y2)
Y2-Y1
- Deviation amount: X2-X1, Y2-Y1
Search area
Y2-Y1
Point
3-43
Setting the Conditions for Each Object Type
POSI-CORRECT SCREEN COND SAVE
1CORRECTION REG.
2ND STAGE CORRECTION
2MODE(1ST)
ANGLE-ADJ.(STANDARD)
3X CORRECT ADJ.(1ST) YES
4X CORRECTION
REG0(0~7) MDL0
5Y CORRECT ADJ.(1ST) YES
6Y CORRECTION
REG0(0~7) MDL0
7ADJUST ANGL.(1ST)
YES
8ADJUST ANGL
REG0(0~7) MDL0
9MODE(2ND)
XY-ADJ.
0X CORRECT ADJ.(2ND) YES
qX CORRECTION
REG0(0~7) MDL0
wY CORRECT ADJ.(2ND) YES
eY CORRECTION
REG0(0~7) MDL0
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
ANGLE ADJ. (STANDARD HIGH)
- X CORRECTION (no/yes)
- Y CORRECTION (no/yes)
ANGLE ADJ. (STANDARD HIGH)
- X CORRECTION (no/yes)
- Y CORRECTION (no/yes)
RED F C1 BRT
NO
1ST STAGE CORRECTION
2ND STAGE CORRECTION
3
NO
XY-ADJ.
ANGLE-ADJ.(STANDARD)
ANGLE-ADJ.(HIGH)
NO
XY-ADJ.