Sharp IV-C35M User Manual page 288

STROBE OUT
When the strobe output setting is specified as "Y*" and the shutter is opened, the output (Y*)
will be turned ON. When the shutter is closed, the output will be turned OFF.
Y*= Y0 to Y7
Note: When you want to use the strobe output, specify a shutter speed between 1/30 and
1/250 seconds.
Ë Strobe output timing
Shutter
Strobe output
(Y*)
'READY'ON
Set the time to turn ON the READY output signal.
(When the measurement start input source is set to parallel, the object type change signal will
also be parallel, and results will be output as parallel signals.)
At the end of an image capture
At the end of a measurement
Setting the Input/Output Conditions
Minimum 4 ms
(1/250 sec.)
Maximum
2 ms
When the controller stops capturing the image, the READY
signal turns ON.
When the controller stops measuring, the READY signal turns
ON.
21-3
21