Sharp IV-C35M User Manual page 176

Object Identification by Binary Conversion
AX.ANGL (axis angle)
Select whether to measure the angle of the longitudinal line
(drawn through the gravity center of the workpiece) to the
horizontal.
FILT (fillet diameter)
Select whether to measure the diameters of horizontal and
vertical fillets on the workpiece.
CIRC-L (peripheral length)
Select whether to count the number of pixels in the
perimeter of the workpiece.
10 MID-PNT
(middle point)
Select whether
to measure the
center point of
the workpiece.
REGISTER NO. (
Register setting conditions are shown for each register number. Circles mean that "REGISTER
EXIST" has set to "YES."
Æ Setting (display) of binary area conditions
0BIN AREA COND
Center of gravity, main axis angle, and center
(0, 0)
Y
Vertical
fillet
diameter
By the combined use of the center point and the center of gravity, a workpiece'
orientation can be measured even when it cannot be evaluated by its spindle axis
BIN AREA COND)
REGISTER NO.
No setting
Center of gravity (X1, Y1)
- Calculated from the area and the position of each object.
X1
- (X1, Y1)=( x/N,
Main axis angle
- Angle between the longitudinal and horizontal directions
(511, 479)
The "MID-PNT" refers to the center point of
horizontal or vertical fillet curves.
Gravity
center
Spindle
axis
angle
Horizontal fillet
diameter
When item "4REGISTER EXIST" is
set to "YES," a circle is displayed.
10-4
Main axis angle
Gravity center
Main axis angle
Fillet width
Fillet width (horizontal)
Peripheral
The number of pixels in
the boundary line of an
object
(stepped are counted as
x 2 pixels)
y/N) N: Area
Gravity center
Center point
Spindle
axis
angle