Setting Operation - Sharp IV-C35M User Manual

Object Identification by Binary Conversion

10-2 Setting operation

Setting the measurement conditions
How to enter the measurement conditions setting screen
1. Select "MAIN-COND" -> "OBJECT TYPE
COND" (menu tree)-> "TYPE00" -> "MEA-CND
(CAMERA1)" -> "MEAS(NEW)," in that order.
Then press the SET key to bring up the
"MEAS1" screen.
2. On the "
"COLOR FILTER" or "EXTRACT COLOR. " On
the " MEAS SELECTION" line, select "LABEL-
10
BIN-OBJ."
For details about the color filter, see page 3-
5.
For detail about the color extraction, see
page 3-10.
3. Press the ESC key to return to the "SELECT OBJECT TYPE COND" screen. Select "MEAS CND"
that is a sub-menu of "MEAS01(LABEL-BIN-OBJ)" and press the SET key to enter the "MEA-CND"
setting screen.
COLOR MODE" line, select either
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS0
POSI-CORRECT
MEAS(NEW)
+ +
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/0
OBJ-TYPE SYS.
TYPE(NEW)
When "COLOR FILTER" is selected on the "1COLOR MODE."
MEASUREMENT1 SCREEN COND SAVE
1COLOR MODE
COLOR FILTER
2COLOR FILTER SET
(TO NEXT SUB-MENU)
3MEAS SELECTION
LABEL-BIN-OBJ
When "EXTRACT COLOR" is selected on the "1COLOR MODE."
MEASUREMENT1 SCREEN COND SAVE
1COLOR MODE
EXTRACT COLOR
2EXTRACT COLOR
(TO NEXT SUB-MENU)
SET
3MEAS SELECTION
LABEL-BIN-OBJ
10-2
COLOR F C1 BRT
1COLOR MODE
2COLOR FILTER SET
3MEAS SELECTION
RED F C1 BRT
COLOR FILTER
EXTRACT COLOR
NO
POSI-DEVATION
CHK-DEG-MATCH
INSPECT-LEAD
INSPECT-BGA/CSP
MEAS-BIN-AREA
CNT-BIN-OBJ
LABEL-BIN-OBJ
POINT-MEAS
MULTI-POSI
MULTI MATCHES
INSPECT NG
COLOR F C1 BRT
COLOR FILTER
EXTRACT COLOR
NO
MEAS-BIN-AREA
CNT-BIN-OBJ
LABEL-BIN-OBJ
COLOR EVALUTION
INSPECT COLOR SHADING
MEAS-CAM-POSI