Sharp IV-C35M User Manual page 237

REGISTER NO.
Select register number to measure. When
making fault inspection, you can select any
register from 0 to 7 (a total of 8 registers).
MODE
Select measurement mode. Select from the
following.
No Does not measure
Measures maximum
PROXIMITY
density difference
DIFFERENCE
between neighbor cells.
Measures maximum
TOTAL
density difference in the
DIFFERENCE
whole area.
MEAS OBJECT
A circle will be placed below the registered number.
How to set the register conditions
How to enter the REG-COND setting screen
There are three methods for getting to the REG-COND setting screen.
1) On the "MEAS CND" setting screen, move
the cursor to " MEAS OBJECT" and press
the SET key. The cursor will move into the
table. Move the cursor to the "Åõ" column
and press the SET key.
Note: If you press the SET key in the "X"
column, the setting will be invalid.
2) On the "MEAS CND" setting screen, press
the TRG/BRT key to move the cursor to the
upper function menu. Select the "COND" item
and then select the "REG-COND" item and
press the SET key.
MEA-CND SCREEN COND SAVE
1REGISTER NO.
0 (0 7)
2MODE
NO
REGISTER NO.
00 01 02 03
3MEAS OBJECT
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
MEA-CND SCREEN COND SAVE
1REGISTER NO.
0 (0 7)
2MODE
PROXIMITY DIFFERENCE
REGISTER NO.
00 01 02 03
3MEAS OBJECT
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
17-3
Fault Inspection
RED F C1 BRT
04 05 06 07 08 09 10 11 12 13 14 15
NO
PROXIMITY DIFFERENCE
TOTAL DIFFERENCE
RED F C1 BRT
04 05 06 07 08 09 10 11 12 13 14 15
IMG PRE-PROC
REG COND
EVALUATION
NUM-CALC
OUT
17