NEC Univerge SV8100 Features And Specifications Manual page 150

Issue 12.0
Program
Program Name
Number
20-08-17 Class of Service Options
(Outgoing Call Service) – ARS
Override of Trunk Access Map
21-02-01 Trunk Group Routing for
Extensions
26-01-01 Automatic Route Selection
Service – ARS Service
26-01-02 Automatic Route Selection
Service – Network Outgoing
Inter-Digit ARS Timer
26-01-03 Automatic Route Selection
Service – ARS Misdialed Number
Handling
26-01-06 Automatic Route Selection
Service – Class of Service Match
Access
2 - 120
Description/Comments
Turn Off or On an extension user
ability to override the trunk access
map programming (Program
14-07-01 and Program 15-06-01)
for outgoing calls.
Assign Program 14-06 routes to
extensions.
Enable/Disable ARS.
With Networking, this timer
replaces Program 20-03-04 when
determining if all network protocol
digits are received. If ARS is
enabled at Site B, this timer can
be programmed for 5 at Site A. If
ARS is disabled and Site B is
using F-Route for outbound
dialing, this timer should be
programmed for 30 at Site A.
If a user dials a number not
programmed in ARS, determine if
the system should Route over
trunk group 1 (0) or Play error tone
(1).
With the ARS Class of Service
Match Access feature, you can
determine whether or not the
system should allow a call based
on the COS assigned to the Dial
Analysis Table (Program 26-02).
This change can be used to create
a tenant-like application. It then
uses the trunk group set in the
Additional Entry in Program
26-02-03 to place the out-going
call. When this feature is enabled,
the calls are routed in sequential
order, and forward – provided the
Class of Service for the trunk
groups match.
UNIVERGE SV8100
Assigned Data
1
0 = Off
1 = On
(default = 0 for COS
01~15)
Day/Night Mode: 1~8
Route Table Number:
0~100
(0 = No Setting)
(default = 1)
0 = Disable (Off)

1 = Enable (On)
(default = 0)
0~64800 (seconds)
(default = 30)
0 = Route to Trunk
Group 1
1 = Play Warning Tone
to Dialer
(default = 0)
0 = Disable (Off)
1 = Enable (On)
(default = 0)
Automatic Route Selection
Level
2 3




