NEC Univerge SV8100 Features And Specifications Manual page 223

UNIVERGE SV8100
Door Box
Virtual Extensions
Voice Response System (VRS)
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
10-09-01 DTMF and Dial Tone Circuit
Setup
11-07-01 Department Group Pilot
Numbers – Dial
11-11-01 Service Code Setup (for Setup/
Entry Operation) – Call Forward
– All
11-11-02 Service Code Setup (for Setup/
Entry Operation) – Call Forward
– Busy
11-11-03 Service Code Setup (for Setup/
Entry Operation) – Call Forward
– No Answer
Call Forwarding, Off-Premise
Description/Comments
Allocate the circuits on the
CD-CP00-US ETUs for either
DTMF receiving or dial tone
detection. Program 14-01-13
Basic Trunk Data Setup – Loop
Supervision Enable (1) loop
supervision for each trunk that
should be able to use Call
Forwarding Off-Premise.
Assign pilot numbers to each
Department Group set up.
Assign the Call Forward All
Service Code.
Assign the Call Forward Busy
Service Code.
Assign the Call Forward No
Answer Service Code.
Assigned Data
1
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
Up to eight digits

(default not assigned)
MLT, SLT
(default = 741)
MLT, SLT
(default = 742)
MLT, SLT
(default = 743)
Issue 12.0
Level
2 3




2 - 193