Projector Basics; Air Filter; Breakers/Power Switches (On/Off) - Christie Roadie HD+35K Setup Manual

3 Operation
This section describes how to use the controls and switches for basic projector operation once it is properly
installed, aligned and configured by a Christie accredited service technician, as described in
Installation and
3.1

Projector Basics

Primary Roadie HD+35K components are:

3.1.1 Air Filter

Intake air flows through the filter before circulating in the front compartment to cool main electronics. Replace
the air filter whenever the lamp is replaced, or sooner in dusty/dirty environments. See Section 4.2 Replacing
the Lamp and Filter in the Roadie HD+35K User Manual for complete instructions.
IMPORTANT! Check condition of the air filter every month.

3.1.2 Breakers/Power Switches (ON/OFF)

The ballast breakers/power switches on the ballast serves two purposes:
1. It is a breaker/power switch for the Roadie HD+35K ballast.
2. It protects against over-current conditions of 50A or more. For China models the rating is 40A or more.
Roadie HD+35K Setup Guide
020-100394-06 Rev. 1 (10-2013)
Setup.
Figure 3-1 Roadie HD+35K Projector and Components
Section 2
3-1