Cleaning The Machine; Cleaning The Exterior; Cleaning The Interior (Led Printheads) - Fuji Xerox apeosport-iv C5570 Administrator's Manual

3 Maintenance

Cleaning the Machine

This section describes how to clean the machine such as the machine exterior,
document cover, document feeder, and document glass.
When cleaning this product, use the designated cleaning materials exclusive to it.
Other cleaning materials may result in poor performance of the product. Never use
aerosol cleaners, or it may catch fire and cause explosion.
When cleaning this product, always switch off the power and then the main power
inside the body front cover, and unplug the product. Access to a live machine interior
may cause electric shock.

Cleaning the Exterior

3
The following describes how to clean the exterior of the machine.
Important • Do not use benzene, paint thinner, or other volatile liquids or spray insect repellent on the
1
Wipe the exterior with a firmly wrung soft
cloth moistened with water.
Important • Do not use cleaning agents other than
Note
2
Wipe off any excess water with a soft cloth.

Cleaning the Interior (LED Printheads)

The following describes how to clean the interior (LED printheads) of the machine.
Normally, clean the LED printheads when you replace the waste toner container.
However, if you have image quality problems such as white or colored stripes appear
on copied or printed outputs, clean the LED printheads.
Important • Clean the LED printheads periodically when you replace the waste toner container.
1
Make sure that the machine is not operating,
and open the front cover.
80
WARNING
CAUTION
machine as they might discolor, deform, or crack covers.
• Cleaning the machine with an excessive amount of water may cause the machine to
malfunction or damage documents during copying.
water or neutral detergent.
• If you cannot remove the dirt easily,
gently wipe the machine with a soft cloth
moistened with a small amount of neutral
detergent.