Rear Cover Open - Xerox Phaser 6000 Service Manual

Error Messages and Codes

Rear Cover Open

Applicable Error
Initial Actions
3-90
A Rear Cover Open error was detected.
• 077-304: Rear Cover Open
• Open and close the Rear Door.
• Cycle printer power.
• If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
Rear Door, PL1.1.6
Interlock Switch, PL1.1.12
LVPS, PL7.2.1
MCU Board, PL7.2.2
Troubleshooting Procedure Table
Step Actions and Questions
1 Visually inspect the Rear Door for
damage.
Is the Rear Door damaged?
2 Enter diagnostic mode and run the
Cover Open Sensor test (see
page 4-11).
Does the number on the display
increase by 1 each time the door is
opened?.
3
Replace the Interlock Switch
(page 8-17 for Phaser 6000/6010, or
page 8-26 for WorkCentre 6015
MFP)?
Does the error persist?
Xerox Internal Use Only
Wiring and Plug/Jack Map References
"Map 3 - Phaser 6000/6010" on
page 10-9
"Phaser 6000/6010 LVPS" on
page 10-11
"Map 3 - WorkCentre 6015 MFP" on
page 10-23
"WorkCentre 6015 MFP LVPS" on
page 10-25
Yes No
Replace the Go step 2.
Rear Door (for
Phaser
6000/6010, or
page 8-24 for
WorkCentre
6015 MFP).
Go to step 4. Go to step 3.
Go to step 4. Complete.
Phaser 6000/6010 and WC 6015 MFP