Paper Remain at Regi
Phaser 6000/6010 and WC 6015 MFP
Paper stuck in the registration section (or Main Paper Tray or Bypass Tray section)
of the Printer was detected.
Applicable Error
•
077-100: Paper Remain at Regi
Initial Actions
•
Check the media path for obstructions or debris.
•
Cycle printer power.
•
If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
Registration Sensor, PL2.3.5
Harness Assembly RKN SNS,
PL2.2.25/26
MCU Board, PL7.2.2
Troubleshooting Procedure Table
Step
Actions and Questions
1
Check connectors P/J12 and P/J120
between the MCU Board and the
Registration Sensor.
Are the connectors secure?
2
Does the error persist?
3
Disconnect the MCU Board P/J21
and the Registration Sensor P/J120.
Check the Harness Assembly RKN
SNS for continuity.
Is the harness damaged?
4
Disconnect the MCU Board P/J12.
Is the voltage across ground and
P/J12-1 +3.3VDC?
Xerox Internal Use Only
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 3 - Phaser 6000/6010" on
page 10-9
"Phaser 6000/6010 Feeder" on
page 10-12
"Phaser 6000/6010 Drive" on
page 10-13
"Map 3 - WorkCentre 6015 MFP" on
page 10-23
"WorkCentre 6015 MFP Feeder" on
page 10-26
"WorkCentre 6015 MFP Drive" on
page 10-27
Yes
Go to step 3.
Go to step 3.
Go to step 4.
Replace the
Registration
Sensor
(page 8-65).
No
Reconnect the
connectors,
then go to
step 2.
Complete.
Repair the
harness.
Replace the
MCU Board
(page 8-121).
3-83