Scanner Adjustment
Phaser 6000/6010 and WC 6015 MFP
When the Scanner or the IP Board are replaced, the Scanner calibration data must
be written to the IP Board for proper Scanner operation. The WorkCentre 6015
MFPs have a Gap Serial Number sticker located at the center rear of the scanner.
This number is the calibration data that is required.
1. Connect the printer to the computer via USB.
2. Start the Grande Gap Writer software.
3. Choose the Scanner from the Scanner List.
4. Enter the Gap Serial Number in the Gap SN box and press Enter.
The information is written to the IP Board.
Xerox Internal Use Only
Adjustment and Calibration
s6015-102
6-11