Figure 6 j0lj41909
6.
Install the Right Cover as shown in the figure. (Figure 7)
Figure 7 j0lj41910
Repairs and Asdjustments
REP 19.4.1 Rear Cover
Parts List on PL 19.2
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
1.
[Machines with One Tray Module]: Remove the STM Connector Cover. (Figure 1)
a.
Remove the screw (x2).
b.
Remove the STM Connector Cover.
2.
[Machines with One Tray Module]: Disconnect the connector. (Figure 2)
a.
Release the Wire Harness from the clamp.
b.
Remove the cable band.
c.
Disconnect the connector.
06/2014
4-68
WARNING
Figure 1 j0mg41902
Version 1.0
WC 5022/5024