Asic Failure - Xerox Phaser 6000 Service Manual

ASIC Failure

Phaser 6000/6010 and WC 6015 MFP
ASIC Failure.
Applicable Error
• 124-333: ASIC Failure
Initial Actions
• Cycle printer power.
• If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
LED Driver Board, PL7.1.5
LED/MCU Cable, PL7.1.6
MCU Board, PL7.2.2
Troubleshooting Procedure Table
Step Actions and Questions
1 Check connectors P/J23 and P/J1 on
the MCU Board and LED Driver
Board.
Are the connections secure?
2 Does the error persist?
3 Disconnect the MCU Board P/J23
and the LED Driver Board P/J1, and
check the LED/MCU Cable
continuity.
Is the cable damaged?
4
Replace the LED Driver Board
(page 8-107).
Does the error persist?
Xerox Internal Use Only
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 3 - Phaser 6000/6010" on
page 10-9
"Phaser 6000/6010 Xerographics" on
page 10-14
"Phaser 6000/6010 Image Processor
Board" on page 10-18
"Map 3 - WorkCentre 6015 MFP" on
page 10-23
"WorkCentre 6015 MFP Xerographics"
on page 10-28
"WorkCentre 6015 MFP Image
Processor Board" on page 10-32
Yes
Go to step 3.
Go to step 3.
Replace the
LED/MCU
Cable
(page 8-111).
Replace the
MCU Board
(page 8-121).
No
Reconnect the
connectors
P/J23 and P/J1,
and then go to
step 2.
Complete.
Go to step 4.
Complete.
3-107