Xerox Phaser 6000 Service Manual page 218

Error Messages and Codes
3-82
Troubleshooting Procedure Table
Step Actions and Questions
15 Does the error still occur when
printing?
16
Enter diagnostic mode and run the
Feed SOLENOID test.
You can also use the CE Diag Tool to
run this test (see page A-16).
Does the Feed Solenoid function
correctly?
17 Check the connection at MCU Board
P/J25.
Is the connection secure?
18
Does the error still occur when
printing?
19 Enter diagnostic mode and select
Engine Diag > Motor Test > Regi
Clutch.
You can also use the CE Diag Tool to
run this test (see page A-16).
Does the Registration Clutch
function correctly?
Xerox Internal Use Only
Yes No
Go to step 16. Complete.
Go to step 17. Replace the
Feed Solenoid
(page 8-98).
Go to step 19. Reconnect the
connector and
then go to
step 18.
Go to step 19. Complete.
Replace the Replace the
MCU Board Registration
(page 8-121). Clutch
(page 8-66).
Phaser 6000/6010 and WC 6015 MFP