Xerox Phaser 6000 Service Manual page 622

Reference
A-24
Test
NVM Settings - Write
NVM Settings - Read
NVM Settings - Save NVM to ESS Saves the internal data of the MCU Board to
Settings - Load NVM from ESS
Print Info
Config Page
Print Settings
Installation Set
Printer Serial Number
Pixel Counter
Tone Correction
Configuration
Print Counter
ESS NVM Init
JOB LOG Init
Apply New Settings
Xerox Internal Use Only
Procedure
Used for changing the settings for internal
data of the printer.
This operation is prohibited since it can
damage the internal data.
Used for confirming the internal data of the
printer.
the Image Processor Board. This is used when
the MCU Board needs to be replaced
Loads the internal data saved via NVM
Settings - SaveNVM to ESS to the new MCU
Board.
The current version of software and the
configuration of the printer can be confirmed
by executing this test. Click the Config Page
button to print the "Config Page".
The service tag, printing count value and
error count value can be confirmed by
executing this test. Click the Print Settings
button to print the "Print Settings" page.
Displays values of the printer's counters and
sets service tags.
To apply changes, click the Apply New
Settings button, or the Restart printer to
apply new settings button.
Serial number of the printer.
Pixel count values of colors Y/M/C/K (read
only).
Specifies whether or not tone correction is
performed.
When the checkmark is placed in the
checkbox, tone correction is performed.
The use of "Configuration" is prohibited since
it is a tool for design development.
Displays the respective counter values in the
master NVM and backup NVM (read only).
Initializes the NVM of the Image Processor
Board.
Initializes the print job history.
This button should be clicked to move to any
other setting menu from the current menu in
operation.
NOTE After completion of all operations the Restart
printer to apply new settings button should be
clicked without exceptions.
Phaser 6000/6010 and WC 6015 MFP