Xerox Phaser 6000 Service Manual page 613

Phaser 6000/6010 and WC 6015 MFP
Test Procedure
CRU Y Example of CRU Y test.
CRU M
1. Power on the printer, and start the CE Diag Tool.
CRU C
2. Open the Toner Door.
CRU K
3. Click the CE Diag tab, and then select Digital Input.
4. Select the CRU Y test, and click the OK button.
5. Check whether the sensor functions properly by removing and
replacing the Y Toner Cartridge.
6. Click the Stop button to stop the test.
7. Close the Toner Door.
NOTE The procedure for CRU M, CRU C, CRU K, and CRU Y are all the same.
Test example:
[09:15]
Digital Input Mode = ENTRY
[09:15]
CRU Y = LOW
STARTED = CRU Y
[09:15]
CRU Y = HIGH
STARTED = CRU Y
[09:15]
CRU Y = LOW
STARTED = IL OPEN
[09:15]
Digital Input Mode = EXIT
Xerox Internal Use Only
Reference
s6000-146
A-15