Deve Mode Change Failure
Phaser 6000/6010 and WC 6015 MFP
Troubleshooting Procedure Table
Step
Actions and Questions
1
Check the connections between the
FAN and LVPS.
Is P/J205 on the LVPS securely
connected?
2
Does the error persist?
3
Disconnect P/J205 on the LVPS.
Is the voltage across ground at
P/J205-1 approximately +24 VDC
when the Interlock Switch is pushed?
4
For the 6010N:
Test the Fan (see "Using Phaser
6010N and WorkCentre 6015 MFP
Service Diagnostics" on page 4-10).
For the 6000:
Test the Fan with the CE Diags Tool
(see page A-16).
Does the Fan function normally?
Applicable Error
•
042-372: Deve Mode Change Failure
Initial Actions
•
Cycle printer power.
•
If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
Feed Solenoid, PL6.1.10
Switching Sensor
Harness Assembly RKN SNS
PL2.2.25/26
Developer Drive Assembly, PL6.1.6
MCU Board, PL7.2.2
Xerox Internal Use Only
Error Messages and Codes
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Complete.
Wiring and Plug/Jack Map References
"Map 3 - Phaser 6000/6010" on
page 10-9
"Phaser 6000/6010 Feeder" on
page 10-12
"Map 3 - WorkCentre 6015 MFP" on
page 10-23
"WorkCentre 6015 MFP Feeder" on
page 10-26
No
Reconnect
connector
P/J205, then
go to step 2.
Complete.
Replace the
LVPS.
Replace the
MCU Board
(page 8-121).
3-73