Phaser 6000/6010 Color Registration With The Printer Setting Utility - Xerox Phaser 6000 Service Manual

Phaser 6000/6010 Color Registration With the Printer Setting Utility

Phaser 6000/6010 and WC 6015 MFP
Note
The Color Registration procedures for the Printer Setting Utility work with USB
connected Phaser 6000B and Phaser 6010N printers.
Enabling/Disabling Automatic Color Registration
Use the following procedure to enable or disable the automatic color registration
adjustment feature.
1. On your computer, click Start > All Programs > Xerox Office Printing > Phaser
6000B/6010N > Printer Setting Utility.
2. Click the Printer Maintenance tab, then select Color Registration
Adjustment from the list.
3. Do one of the following:
• To enable the feature, click to select On for Automatic Registration
Adjustment.
• To disable the feature, click to clear the check for Automatic Registration
Adjustment.
4. Click the Apply New Settings button to accept the change.
Performing an Automatic Color Registration Adjustment
Use the following procedure to perform the automatic color registration
adjustment.
Note
An automatic color registration adjustment is performed every time a new
Toner Cartridge is installed.
1. On your computer, click Start > All Programs > Xerox Office Printing > Phaser
6000B/6010N > Printer Setting Utility.
2. Click the Printer Maintenance tab, then select Color Registration
Adjustment from the list.
3. Click the Start button next to Auto Correct. The Automatic Color Registration
routine runs.
Note
The Phaser 6000B only corrects the X axis. If skew is a problem, click the Start
button next to Print Color Regi Chart and adjust the left and right values.
Xerox Internal Use Only
Adjustment and Calibration
6-3