•
Press FNC
•
Press HOLD
•
Press *
•
Press #
If you wish to leave system programming, you can do so by pressing SPKR.
Once you have changed any settings, you need to press MIC to store them. You can
move around on the display by using your * and # keys. Use * to move left, use # to
move right.
2-01 : Tenant CO/PBX Line Accommodation
This Memory Block area is used to specify which tenants will have access to each
CO/PBX line.
•
Enter system programming mode
•
Press Line Key 2
•
Dial 0 1
•
Enter value for tenant (0-3)
•
Enter value for CO/PBX line (1-8)
•
Enter access value
0 - Deny
o
1 - Allow
o
•
Press MIC to store the data
•
Press SPKR to go back on line
Note: (*) indicates default value
1-01 : Hookflash Time Selection
This memory block is used to enter the instantaneous break time of a Hookflash signal
to be sent to a CO/PBX line when the RECALL key on a Proprietary telephone is
pressed and the Hookflash end time for Single Line Telephones.
•
Enter system programming Mode
•
Press Line Key 1
•
Dial 0 1
•
Enter value for CO/PBX line (field 1)
0 - 0.4sec delay (*)
o
1 - 0.6sec delay
o
2 - 1.0sec delay
o
3 - 1.5sec delay
o
•
Enter value for SLT
0 - 0.4sec delay
o
1 - 0.6sec delay
o
2 - 1.0sec delay(*)
o
3 - 1.5sec delay
o
•
Press MIC to store the data
•
Press SPKR to go back on line
15