Suzuki AN400 Service Manual page 38

0B-11 Maintenance and Lubrication:
Drive V-belt Removal and Installation
Inspect drive V-belt
Every 12 000 km (7 500 miles, 24 months)
Replace drive V-belt
Every 24 000 km (14 500 miles, 48 months)
Refer to "V-belt Type Continuously Variable Automatic
Transmission Removal and Installation in Section 5A
(Page5A-3)".
Drive V-belt Inspection
Inspect the drive V-belt in the following procedures:
1) Remove the clutch covers. Refer to "V-belt Type
Continuously Variable Automatic Transmission
Removal and Installation in Section 5A (Page5A-3)".
2) Inspect the drive V-belt for crack or other damage
and measure the width of belt if necessary. If any
abnormal point are found, replace the drive V-belt
with a new one. Refer to "V-belt Type Continuously
Variable Automatic Transmission Removal and
Installation in Section 5A (Page5A-3)".
3) Install the clutch covers. Refer to "V-belt Type
Continuously Variable Automatic Transmission
Removal and Installation in Section 5A (Page5A-3)".
Throttle Cable Play Inspection and Adjustment
Inspect throttle cable play
Initially at 1 000 km (6 000 miles, 2 month) and every
6 000 km (4 000 miles, 12 months) thereafter
Inspect and adjust the throttle cable play "a" as follows.
Throttle cable play "a"
2.0 – 4.0 mm (0.08 – 0.16 in)
B705H10206029
B705H10206030
I705H1020052-01
B705H10206031
"a"
I705H1020020-01
1) Loosen the lock-nut (1) of the throttle pulling cable
(2).
2) Turn the adjuster (3) in or out until the throttle cable
play "a" (at the throttle grip) is between 2 – 4 mm
(0.08 – 0.16 in).
3) Tighten the lock-nut (1) while holding the adjuster
(3).
1
WARNING
!
After the adjustment is completed, check that
handlebar movement does not raise the
engine idle speed and that the throttle grip
returns smoothly and automatically.
Cooling System Inspection
Engine Coolant Level Inspection
Inspect cooling system
Every 6 000 km (4 000 miles, 12 months)
Replace engine coolant
Every 2 years
1) Keep the motorcycle upright with the center stand.
2) Open the fuel lid.
3) Check the engine coolant level by observing the full
and lower lines on the engine coolant reservoir tank.
If the level is below the lower line, add engine
coolant to the full line from the engine coolant
reservoir tank filler.
2
3
I705H1020021-01
B705H10206015
I705H1020022-01
I705H1020023-02