NOTE
• Be sure to apply engine oil to tappet shim
top and bottom faces.
• When seating the tappet shim, be sure the
figure printed surface faces the tappet.
7) Rotate the engine so that the tappet is depressed
fully. This will squeeze out oil trapped between the
shim and the tappet that could cause an incorrect
measurement, then check the clearance again to
confirm that it is within the specified range.
8) Install the cylinder head cover. Refer to "Engine Top
Side Assembly in Section 1D (Page1D-18)".
9) Install the spark plug and plug cap. Refer to "Spark
Plug Removal and Installation (Page0B-3)".
10) Install other removed parts.
Fuel Line Inspection
Inspect fuel line
Every 6 000 km (4 000 miles, 12 months)
Inspect the fuel line in the following procedures:
1) Remove the helmet box front cover. Refer to "Helmet
Box Removal and Installation in Section 9D
(Page9D-21)".
2) Remove the front frame cover. Refer to "Front Frame
Cover Removal and Installation in Section 9D
(Page9D-17)".
3) Inspect the fuel line (1) for damage and fuel leakage.
If any defects are found, the fuel line must be
replaced.
I310G1020026-01
4) Reinstall the removed parts.
Evaporative Emission Control System (E-33
Only)
Inspect evaporative emission control system
Every 12 000 km (7 500 miles, 24 months)
Inspect the evaporative emission control system
periodically (E-33 only).
Maintenance and Lubrication:
1
1
0B-8
B705H10206006
I705H1020050-01
I705H1020051-01
B705H10206025