3: Service Setup; Factory Mode And Service Mode; Factory Mode - Christie E Series Service Manual

3 Service Setup
This section describes special adjustments and related details that may require the attention of a Christie
accredited service technician, whether done periodically or after a specific module replacement.
3.1

Factory Mode and Service Mode

The DWU675-E/DHD675-E/DWU775-E/DHD775-E provides 2 menus that are restricted to personnel with
service level access:

3.1.1 Factory Mode

Perform the following actions to enter Factory Mode:
1. Turn on the projector.
2. Press A
UTO
NOTE: If signal is present at one of the inputs, it will be necessary to press the M
sequence.
Table 3.1 Factory Mode
FACTORY MODE
Model Name
Optional
PW392 FW Ver
PIC FW Ver
PW808 FW Ver
GEO-A FW Ver
GEO-B FW Ver
Waveform Ver.
Factory Reset
ADC Calibration
Color Speed
Color Wheel Index
Waveform ID
Burn In
DA Home
DA
ABC DA Step
ABC Feedback
E Series 675/775 Service Manual
020-000546-04 Rev. 1 (04-2017)
LEFT LEFT LEFT
, , , keys sequentially on the Remote Keypad or the Built-in Keypad.
Show Model Name
Displays which optional hardware is installed: Color Wheel and PW610/GEO
board
Displays main scaler Firmware version
Displays PIC/Keypad version
Displays LAN Firmware version
Displays Firmware version of chip A on GEO/Warping board
Displays Firmware version of chip B on GEO/Warping board
Show Waveform ID
Perform factory reset
Perform calibration of ADC chip (Analog to Digital convertor)
Press S
ELECT
key to switch Color Wheel Speed to 2x or 3x
Color Wheel Index
Display Waveform ID version
Enter Burn In Mode Menu
Set DA (Dynamic Aperture) home position
Change DA position (open or close)
Displays step position of Dynamic Aperture for Auto Brightness setting
Shows feedback on Auto Brightness setting
DESCRIPTION
Section 3: Service Setup
ENU
key before using this
3-1