Installation Of Radio System; Electrical System; Electrical Parts; Wiring Harness - Mazda CX-7 2007 Workshop Manual

2007 mazda cx-7
Hide thumbs Also See for CX-7 2007:
Table of Contents

Advertisement

INSTALLATION OF RADIO SYSTEM

• If a radio system is installed improperly or if a high-powered type system is used, the CIS and other systems
may be affected. When the vehicle is to be equipped with a radio, observe the following precautions:
— Install the antenna at the farthest point from control modules.
— Install the antenna feeder as far as possible from the control module wiring harnesses.
— Ensure that the antenna and feeder are properly adjusted.
— Do not install a high-powered radio system.
End Of Sie

ELECTRICAL SYSTEM

Electrical Parts

Battery cable
• Before disconnecting connectors or removing
electrical parts, disconnect the negative battery
cable.

Wiring Harness

• To remove the wiring harness from the clip in the
engine room, pry up the hook of the clip using a
flathead screwdriver.
Caution
• Do not remove the wiring harness
protective tape. Otherwise, the wires
could rub against the body, which could
result in water penetration and electrical
shorting.
00-00–20
GENERAL INFORMATION
id000000800300
id000000800400
BATTERY CABLE
acxuuw00000451
acxuuw00000452
NO GOOD
acxuuw00000453

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents