Fuse; Viewing Orientation For Connectors - Mazda CX-7 2007 Workshop Manual

Fuse

Replacement
• When replacing a fuse, be sure to replace it with one of the same capacity. If a fuse malfunctions again, the
circuit probably has a short and the wiring should be inspected.
• Be sure the negative battery terminal is disconnected before replacing a main fuse.
• When replacing a pullout fuse, use the fuse puller.

Viewing orientation for Connectors

• The viewing orientation for connectors is indicated with a symbol.
• The figures showing the viewing orientation are the same as those used in Wiring Diagrams.
• The viewing orientations are shown in the following three ways.
Part-side connector
The viewing orientation for part-side connectors is
from the terminal side.
* : Part names are shown only when there are
multiple connector drawings.
Vehicle harness-side connector
The viewing orientation for vehicle wiring harness-
side connectors is from the wiring harness side.
* : Part names are shown only when there are
multiple connector drawings.
00-00–24
GENERAL INFORMATION
CONNECTOR
CONNECTOR
VEHICLE WIRING
HARNESS-SIDE
CONNECTOR
FUSE
PCM
PART
PART-SIDE CONNECTOR
NAME OF CONNECTING
PART*
PCM
VEHICLE WIRING HARNESS
PULLER
acxuuw00000464
PART NAME*
VIEWING
ORIENTATION
SYMBOL
VIEWING ORIENTATION
acxuuw00000472
VIEWING
ORIENTATION
SYMBOL
VIEWING ORIENTATION
acxuuw00000473