Reassembly
• Standard values, such as torques and certain
adjustments, must be strictly observed in the
reassembly of all parts.
• If removed, these parts should be replaced with
new ones:
— Oil seals
— Gaskets
— O-rings
— Lock washers
— Cotter pins
— Nylon nuts
• Depending on location:
— Sealant and gaskets, or both, should be
applied to specified locations. When sealant
is applied, parts should be installed before
sealant hardens to prevent leakage.
— Oil should be applied to the moving
components of parts.
— Specified oil or grease should be applied at
the prescribed locations (such as oil seals)
before reassembly.
Adjustment
• Use suitable gauges and testers when making
adjustments.
Rubber Parts and Tubing
• Prevent gasoline or oil from getting on rubber
parts or tubing.
00-00–16
GENERAL INFORMATION
acxuuw00000014
acxuuw00000326
acxuuw00000016
acxuuw00000017