Mazda Radar Cruise Control With; Stop & Go Function; Transmission) - Mazda Mazda3 2019 Owner's Manual

When Driving
i-ACTIVSENSE
NOTE
If the set speed is not indicated in the
display, the control does not resume even
if the RES switch is pressed.
Turning off the system
When the MRCC switch is pressed while
the MRCC is operating, the MRCC turns
off.
▼ Shift-up/Shift-down Request Display
The shift-up or shift-down request display
might be displayed while the MRCC is
operating. When this occurs, shift gears
because the gear position is not
appropriate.
Request
Shift up Shift Up to a Higher Gear
Shift down Shift Down to a Lower Gear
NOTE
If the gears are not shifted up even

though the shift-up request indication is
displayed, load will be applied to the
engine and the MRCC might be
automatically cancelled or engine
damage could occur.
If the gears are not shifted down even

though the shift-down request indication
is displayed, the MRCC might be
automatically cancelled or engine
stalling could occur.
4-128
Indication on display
Mazda Radar Cruise
Control with Stop & Go
function (MRCC with Stop
& Go function) (Automatic

Transmission)

▼ Mazda Radar Cruise Control with

Stop & Go function (MRCC with
Stop & Go function)
The MRCC with Stop & Go function
system is designed to maintain headway
*1
control with a vehicle ahead according
to your vehicle's speed using a front radar
sensor to detect the distance to the vehicle
ahead and a preset vehicle speed without
you having to use the accelerator or brake
pedals.
*
1 Headway Control: Control of the
distance between your vehicle and the
vehicle ahead detected by the Mazda
Radar Cruise Control (MRCC)
system.
Additionally, if your vehicle starts closing
in on the vehicle ahead such as if the
vehicle ahead brakes suddenly, a warning
sound and a warning indication in the
display are activated simultaneously to
alert you to maintain a sufficient distance
between the vehicles.
If the vehicle ahead stops while you are
following behind it, your vehicle will stop
and be held stopped automatically (stop
hold control), and headway control will
resume when you resume driving the
vehicle such as by pressing the RES
switch.
Also refer to the following before using
the MRCC with Stop & Go function.