Mazda CX-7 2007 Workshop Manual page 91

STEP
5 INSPECT PCM CONNECTOR FOR POOR
CONNECTION
• Disconnect the PCM connector.
• Check for poor connection (damaged, pulled-
out pins, corrosion, etc.).
• Is there any malfunction?
6 VERIFY TROUBLESHOOTING OF DTC P0101
COMPLETED
• Make sure to connect all disconnected
connectors.
• Turn ignition switch to the ON position (Engine
off).
• Clear the DTC from the PCM memory using
the M-MDS.
• Start the engine.
• Warm-up engine until ECT PID is above 70°C
{158°F}.
• Idle engine for 5 s or more.
Caution
• While performing the Drive Mode,
always operate the vehicle in a safe
and lawful manner.
• Drive the vehicle under the following two
conditions:
Condition 1
— TP PID:50— 87.5%
— RPM PID: above 1,000 rpm
— 4th gear
Condition 2
— TP PID: above 80%
— RPM PID: below 2,000 rpm
— gear in
• Is the PENDING CODE for this DTC present?
7 VERIFY AFTER REPAIR PROCEDURE
• Perform the "After Repair Procedure".
(See01-02-10 AFTER REPAIR
PROCEDURE[L3 WITH TC])
• Are any DTCs present?
End Of Sie
ON-BOARD DIAGNOSTIC [L3 WITH TC]
INSPECTION
Yes Repair terminal, then go to the next step.
No Go to the next step.
Yes Replace the PCM, then go to the next step.
No Go to the next step.
Yes Go to the applicable DTC inspection.
(See01-02-13 DTC TABLE[L3 WITH TC])
No Troubleshooting completed.
ACTION
01-02–49
01-02