Dtc P0610 [Z6] - Mazda 3 Workshop Manual

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
• Verify related service repair information
2
availability.
• Is any related repair information
available?
VERIFY TROUBLESHOOTING OF DTC
P0602 COMPLETED
• Make sure to reconnect all disconnected
connectors.
3
• Clear the DTC from the PCM memory
using the WDS or equivalent.
• Start the engine.
• Is the same DTC present?
VERIFY AFTER REPAIR PROCEDURE
• Perform the "AFTER REPAIR
PROCEDURE".
4
(See AFTER REPAIR PROCEDURE
[Z6].)
• Are any DTCs present?
DTC P0610
DETECTION
CONDITION
POSSIBLE CAUSE
Downloaded from
Yes
No
Yes
No Go to the next step.
Yes
No DTC troubleshooting completed.

DTC P0610 [Z6]

• PCM data configuration error.
Diagnostic support note
• This is a continuous monitor (CCM).
• The MIL illuminates if the PCM detects the above malfunction condition in the
first drive cycle.
• PENDING CODE is available if the PCM detects the above malfunction
condition.
• FREEZE FRAME DATA is available.
• The DTC is stored in the PCM memory.
• Configuration procedure has not been completed
• PCM malfunction
https://carmanualshub.com/
Perform repair or diagnosis according to the
available repair information.
• If the vehicle is not repaired, go to the next
step.
Perform the "PCM CONFIGURATION", then go
to the next step.
(See PCM CONFIGURATION
Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION
Go to the applicable DTC inspection.
(See DTC TABLE [Z6].)
PCM vehicle options error
- automotive repair manuals website
[Z6].)
[Z6].)
B3E010200600W02