Arrangement Of Parts; Cleaning Of Parts; Reassembly; Adjustment - Mazda 2006-2008 RX7 Engine Workshop Manual

Arrangement of Parts

• All disassembled parts should be carefully
arranged for reassembly.
• Be sure to separate or otherwise identify the parts
to be replaced from those that will be reused.

Cleaning of Parts

• All parts to be reused should be carefully and
thoroughly cleaned in the appropriate method.
Warning
• Using compressed air can cause dirt and
other particles to fly out causing injury to
the eyes. Wear protective eye wear
whenever using compressed air.

Reassembly

• Standard values, such as torques and certain
adjustments, must be strictly observed in the
reassembly of all parts.
• If removed, the following parts should be replaced
with new ones:
— Oil seals
— Gaskets
— O-rings
— Lockwashers
— Cotter pins
— Nylon nuts
• Depending on location:
— Sealant and gaskets, or both, should be
applied to specified locations. When sealant
is applied, parts should be installed before
sealant hardens to prevent leakage.
— Oil should be applied to the moving
components of parts.
— Specified oil or grease should be applied at
the prescribed locations (such as oil seals)
before reassembly.

Adjustment

• Use suitable gauges and testers when making
adjustments.
GENERAL INFORMATION
00–00
WGIWXX0029E
C5U0000W001
WGIWXX0031E
CHU0014W006
CHU0014W005
00–00–7