T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
Syntax
user access-control mac-based mac-addr
no user access-control
Parameter
mac-addr —— The source MAC address. Only the user with this MAC Address
is allowed to login.
Command Mode
Global Configuration Mode
Example
Configure that only the user with the MAC address 00:00:13:0A:00:01 is allowed
to login:
T3700G-28TQ(config)#user access-control mac-based 00:00:13:0A:00:01
user access-control port-based
Description
The user access-control port-based command is used to limit the ports for
login. Only the users connected to these ports you set here are allowed for login.
To cancel the user access limit, please use no user access-control command.
At most 5 ports can be configured.
Syntax
user access-control port-based interface { fastEthernet port | gigabitEthernet
port | ten-gigabitEthernet port | none}
no user access-control
Parameter
port
none
Command Mode
Global Configuration Mode
Example
Configure that only the users connected to Gigabit Ethernet ports 2 are allowed to
login:
——
The Fast/Gigabit/ten-Gigabit Ethernet port number.
——
Set the access port list to be none.
74