Ip Igmp Snooping Multi-Vlan-Config - TP-Link JetStream T3700G-28TQ Reference Manual

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
maxgroup —— Specify the maximum numbers of groups that the port can join.
It ranges from 0 to 1024 and the default value is 1024.
drop —— When the number of the dynamic multicast groups that a port joins
has exceeded the max-group, the port will not join any new multicast group.
replace —— When the number of the dynamic multicast groups that a port joins
has exceeded the max-group, the newly joined multicast group will replace one
of the old entries randomly.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Specify the maximum numbers of groups that ports 1/0/2-5 can join as 10, and
configure the throttling action as replace:
T3700G-28TQ(config)#interface range gigabitEthernet 1/0/2-5
T3700G-28TQ(config-if-range)#ip igmp snooping max-groups 10
T3700G-28TQ(config-if-range)#ip igmp snooping max-groups action
replace

ip igmp snooping multi-vlan-config

Description
The ip igmp snooping multi-vlan-config command is used to create and
configure a Multicast VLAN. To delete the corresponding Multicast VLAN,
please use no ip igmp snooping multi-vlan-config command.
Syntax
ip igmp snooping multi-vlan-config [vlan-id] { rtime router-time | mtime
member-time | ltime leave-time | rport interface { fastEthernet port |
gigabitEthernet port | ten-gigabitEthernet port } }
no ip igmp snooping multi-vlan-config
Parameter
vlan-id —— The ID of the VLAN desired to modify configuration, ranging from 2
to 4094.
228