Ip Rip V2-Broadcast; Ip Rip Authentication-Mode - TP-Link JetStream T3700G-28TQ Reference Manual
Jetstream 28-port gigabit stackable l3 managed switch
Hide thumbs
Also See for JetStream T3700G-28TQ:
- User manual (430 pages) ,
- Cli reference manual (424 pages) ,
- Installation manual (40 pages)
Table of Contents
Advertisement
T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
ip rip v2-broadcast
Description
The ip rip v2-broadcast command is used to configure the desired interface to
send RIPv2 packets via broadcast. By default, interfaces send RIPv2 packets
via multicast, and the multicast IP address is 224.0.0.9. To return to the default
configuration, please use no ip rip v2-broadcast command.
Syntax
ip rip v2-broadcast
no ip rip v2-broadcast
Command Mode
Interface Configuration Mode
Example
Configure the interface VLAN2 to send RIPv2 packets via broadcast:
T3700G-28TQ(config)# interface vlan 2
T3700G-28TQ(config-if)# ip rip v2-broadcast
ip rip authentication-mode
Description
The ip rip authentication-mode command is used to configure the
authentication mode of RIP on the desired interface. By default, the
authentication mode is none, that is, use no authentication.
Syntax
ip rip authentication-mode {md5 key-id key-string | simple key-string | none}
Parameter
md5 key-id key-string — Enter the authentication key ID and key string if you
choose the MD5 authentication mode. The key ID ranges from 1 to 255. The
length of the key string is up to 16 octets.
simple key-string —— Enter the authentication key string if you choose the
simple authentication mode. The length of the key string is up to 16 octets.
none —— Do not use any authentication.
349
Advertisement
Table of Contents
