Auto-Cost - TP-Link JetStream T3700G-28TQ Reference Manual
Jetstream 28-port gigabit stackable l3 managed switch
Hide thumbs
Also See for JetStream T3700G-28TQ:
- User manual (430 pages) ,
- Cli reference manual (424 pages) ,
- Installation manual (40 pages)
Table of Contents
Advertisement
T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
use the no default-information originate command with corresponding
parameters.
Syntax
default-information originate [ always ] [ metric cost ] [ metric-type type ]
no default-information originate [ always ] [ metric cost ] [ metric-type
type ]
Parameter
always —— OSPF will advertise the default route whether there is default route
is the IP routing table or not. If the parameter is not configured, OSPF will
advertise the default route only when there is default route in the IP routing
table.
cost——The default cost of the default route, ranging form 1 to 16777214. Its
default value is 1.
type —— The type of the external routes, either 1 or 2. The default value is 2.
Command Mode
Router Configuration Mode
Example
Configure OSPF to advertise the default route whether there is default route is
the IP routing table or not:
T3700G-28TQ(config)# router ospf 1
T3700G-28TQ(config-router)# default-information originate always
auto-cost
Description
The auto-cost command is used to enable the auto computing function of the
interface cost and configure the reference bandwidth. The interface cost is the
ratio of the reference bandwidth to the interface bandwidth. To restore the
reference bandwidth to default value, please use the no auto-cost
reference-bandwidth command. To disable the auto computing function of the
interface cost, please use the no auto-cost command without parameters.
Syntax
auto-cost [ reference-bandwidth bandwidth ]
358
Advertisement
Table of Contents
