Ip Igmp Static-Group (Interface Vlan) - TP-Link JetStream T3700G-28TQ Reference Manual

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
Parameter
count —— Specify the number of Startup Query Messages that the switch
sends. The default value is 2.
Command Mode
Interface Configuration Mode
Example
Configure the number of Startup Query Messages that the switch sends as 3 on
Interface VLAN 2:
T3700G-28TQ(config)# interface vlan 2
T3700G-28TQ(config-if)# ip igmp last-member-query-count 3

ip igmp static-group (interface vlan)

Description
The ip igmp static-group command is used to configure the static multicast
group on specified interface VLAN. To delete the corresponding multicast
source and group on this interface VLAN, please use no ip igmp static-group
command.
Syntax
ip igmp static-group group-address interface { fastEthernet | gigabitEthernet |
ten-gigabitEthernet } port-list [ source source-address ]
no ip igmp static-group
Parameter
group-address
224.0.1.0~239.255.255.255
fastEthernet | gigabitEthernet | ten-gigabitEthernet —— The port type.
port-list —— List of the forwarding ports, in the format of 1/0/1 or 1/0/5-8.
source-address —— The source of the static multicast group. It is a unicast
address.
Command Mode
Interface Configuration Mode (interface vlan)
—— The multicast
308
address, ranging from