Lldp Med-Fast-Count - TP-Link JetStream T3700G-28TQ Reference Manual

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
Syntax
lldp tlv-select { [ port-description ] [ system-capability ] [ system-description ]
[ system-name ] [ management-address ] [ port-vlan ] [ protocol-vlan ]
[ vlan-name ] [ link-aggregation ] [ mac-phy-cfg ] [ max-frame-size ] [ power ]
[ all ] }
no lldp tlv-select { [ port-description ] [ system-capability ] [ system-description ]
[ system-name ] [ management-address ] [ port-vlan ] [ protocol-vlan ]
[ vlan-name ] [ link-aggregation ] [ mac-phy-cfg ] [ max-frame-size ] [ power ]
[ all ] }
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Exclude "management-address" and "port-vlan-id" TLVs in LLDPDU outgoing
from Gigabit Ethernet port 1:
T3700G-28TQ(config)# interface gigabitEthernet 1/0/1
T3700G-28TQ(config-if)# no lldp tlv-select management-address port-vlan

lldp med-fast-count

Description
The lldp med-fast-count command is used to configure the number of the
LLDP-MED frames that will be sent out. When LLDP-MED fast start mechanism
is activated, multiple LLDP-MED frames will be transmitted based on this
parameter. The default value is 4. To return to the default configuration, please
use no lldp med-fast-count command.
Syntax
lldp med-fast-count count
no lldp med-fast-count
Parameter
count —— Configure the Fast Start Count parameter. It ranges from 1 to 10. By
default, it is 4.
Command Mode
Global Configuration Mode
261