Chapter 21 Mac Address Commands; Mac Address-Table Static - TP-Link JetStream T3700G-28TQ Reference Manual

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide

Chapter 21 MAC Address Commands

MAC Address configuration can improve the network security by configuring the Port Security and
maintaining the address information by managing the Address Table.

mac address-table static

Description
The mac address-table static command is used to add the static MAC address
entry. To remove the corresponding entry, please use no mac address-table
static command. The static address can be added or removed manually,
independent of the aging time. In the stable networks, the static MAC address
entries can facilitate the switch to reduce broadcast packets and enhance the
efficiency of packets forwarding remarkably.
Syntax
mac address-table static mac-addr vid vid interface { fastEthernet port |
gigabitEthernet port | ten-gigabitEthernet port }
no mac address-table static { mac-addr | vid vid | mac mac-addr vid vid |
interface { fastEthernet port | gigabitEthernet port | ten-gigabitEthernet
port } }
Parameter
mac-addr —— The MAC address of the entry you desire to add.
vid —— The VLAN ID number of your desired entry. It ranges from 1 to 4094.
port
Command Mode
Global Configuration Mode
Example
Add a static Mac address entry to bind the MAC address 00:02:58:4f:6c:23,
VLAN1 and Gigabit Ethernet port 1/0/1 together:
T3700G-28TQ(config)#mac address-table static 00:02:58:4f:6c:23 vid 1
interface gigabitEthernet 1/0/1
Delete the static address entry whose VLAN id is 1:
—— The Fast/Gigabit Ethernet port number.
127