TP-Link JetStream T3700G-28TQ Reference Manual page 38

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
Mode Accessing Path
Layer 2 Interface:
Use
gigabitEthernet
interface
gigabitEthernet
command to enter this mode
from
mode.
Interface
Layer 3 Interface:
Configuration
Use
Mode
command to enter Routed Port
mode
Configuration mode.
Use the interface vlan vlan-id
command
Interface mode from Global
Configuration mode.
Use the interface loopback id
command to enter Loopback
Interface mode from Global
Configuration mode.
Use the ip dhcp server pool
DHCP
pool-name command to enter
Configuration
DHCP
from
Mode
mode.
Use the spanning-tree mst
MST
configuration
Configuration
enter this mode from Global
Mode
Configuration mode.
Note:
1. The user is automatically in User EXEC Mode after the connection between the PC and
the switch is established by a console port or by a telnet connection.
2. Each command mode has its own set of specific commands. To configure some
commands, you should access the corresponding command mode firstly.
Global Configuration Mode: In this mode, global commands are provided, such as

the Spanning Tree, Schedule Mode and so on.
the interface
port or
range
port-list
Global Configuration
the no switchport
from Interface
to enter VLAN
T3700G-28TQ(config-if-
range)#
Configuration Mode T3700-28TQ(config-dhcp)
Global Configuration
command to
T3700G-28TQ(config- mst)#
Prompt
T3700G-28TQ(config-if)#
T3700G-28TQ(config-if- range)#
T3700G-28TQ(config-if)#
19
Logout or Access the
next mode
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to
Global Configuration
mode.
A port number must be
specified in the interface
command.
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to
Global Configuration
mode.
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to
Global Configuration
mode.
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to
Global configuration mode.