User Access-Control Port-Based; User Max-Number - TP-Link T3700G-28TQ Cli Reference Manual

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide

user access-control port-based

Description
The user access-control port-based command is used to limit the ports for
login. Only the users connected to these ports you set here are allowed for login.
To cancel the user access limit, please use no user access-control command.
At most 5 ports can be configured.
Syntax
user access-control port-based interface { fastEthernet port | gigabitEthernet
port | ten-gigabitEthernet port | none}
no user access-control
Parameter
port —— The Fast/Gigabit/ten-Gigabit Ethernet port number.
none —— Set the access port list to be none.
Command Mode
Global Configuration Mode
Example
Configure that only the users connected to Gigabit Ethernet ports 2 are allowed to
login:
T3700G-28TQ(config)#user
gigabitEthernet 1/0/2

user max-number

Description
The user max-number command is used to configure the maximum login user
number at the same time. To cancel the limit on login number, please use no
user max-number command.
Syntax
user max-number admin-num guest-num
no user max-number
access-control
80
port-based interface