Ip Arp Inspection(Interface) - TP-Link JetStream T3700G-28TQ Reference Manual

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Configure the Gigabit Ethernet ports 1/0/2-5 as the Trusted Port:
T3700G-28TQ(config)#interface range gigabitEthernet 1/0/2-5
T3700G-28TQ(config-if-range)#ip arp inspection trust

ip arp inspection(interface)

Description
The ip arp inspection command is used to enable the ARP Defend function. To
disable the ARP detection function, please use no ip arp inspection command.
ARP Attack flood produces lots of ARP Packets, which will occupy the
bandwidth and slow the network speed extremely. With the ARP Defend
enabled, the switch can terminate receiving the ARP packets for 300 seconds
when the transmission speed of the legal ARP packet on the port exceeds the
defined value so as to avoid ARP Attack flood.
Syntax
ip arp inspection
no ip arp inspection
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable the arp defend function for the Gigabit Ethernet ports 1/0/2-6:
T3700G-28TQ(config)#interface range gigabitEthernet 1/0/2-6
T3700G-28TQ(config-if-range)#ip arp inspection
92