User Access-Control Port-Based; Line - TP-Link TL-SG3210 Cli Reference Manual

user access-control port-based

Description
The user access-control port-based command is used to limit the ports for
login. Only the users connected to these ports you set here are allowed to login.
To cancel the user access limit, please use no user access-control command.
Syntax
user access-control port-based interface { gigabitEthernet port | range
gigabitEthernet port-list } [ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all ]
no user access-control
Parameter
port —— The Ethernet port number.
port-list ——The list group of Ethernet ports, in the format of 1/0/1-4. You can
appoint 5 ports at most.
[ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all ] —— Specify the access
interface. These interfaces are enabled by default.
Command Mode
Global Configuration Mode
Example
Configure that only the users connected to ports 2-6 are allowed to login:
TL-SG3424(config)# user access-control port-based interface range
gigabitEthernet 1/0/2-6

line

Description
The line command is used to enter the Line Configuration Mode and make
related configuration for the desired user(s), including the login mode and
password configurations.
Syntax
line [ console linenum | vty startlinenum endlinenum ]
55