T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
Syntax
ip ospf priority pri
no ip ospf priority
Parameter
pri —— The priority of the interface, ranging from 0 to 255 and the default value
is 1. Interface with the priority 0 can not be elected as DR or BDR.
Command Mode
Interface Configuration Mode
Example
Configure the priority of the interface VLAN 2 as 1:
T3700G-28TQ(config-if)# ip ospf priority 1
ip ospf hello-interval
Description
The ip ospf hello-interval is used to configure the hello intervals on the
specified interface. To restore to the default value, please use the no ip ospf
hello-interval command.
Syntax
ip ospf hello-interval interval
no ip ospf hello-interval
Parameter
Interval —— The interval of the hello packets, ranging from 1 to 65535 seconds
and the default value is 10 seconds.
Command Mode
Interface Configuration Mode
Example
Configure the interval of the hello packets sent on interface VLAN 2 as 20
seconds:
T3700G-28TQ(config-if)# ip ospf hello-interval 20
375