Passive-Interface Default - TP-Link JetStream T3700G-28TQ Reference Manual

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
Syntax
passive-interface range
ten-gigabitEthernet } port-list | loopback id-list | vlan vlan-list }
no
ten-gigabitEthernet } port-list| loopback id-list | vlan vlan-list }
Parameter
fastEthernet | gigabitEthernet | ten-gigabitEthernet —— The port type of the
interfaces.
port-list —— The ports' number.
id-list —— The interface loopback IDs.
vlan-list —— The interface VLAN IDs.
Command Mode
Router Configuration Mode
Example
Prevent interface VLAN 1-3 from sending OSPF packets in routing process 1:
T3700G-28TQ(config)# router ospf 1
T3700G-28TQ(config-router)# passive-interface vlan 1-3

passive-interface default

Description
The passive-interface default command is used to prevent all the interfaces
from sending OSPF packets. To restore to the default settings, please use no
passive-interface default command. All the interfaces are allowed to send
OSPF packets by default.
Syntax
passive-interface default
no passive-interface default
Command Mode
Router Configuration Mode
passive-interface range
{ { fastEthernet
{ { fastEthernet
363
| gigabitEthernet
| gigabitEthernet
|
|