Ip Pim Rp-Candidate Interface - TP-Link JetStream T3700G-28TQ Reference Manual

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
T3700G-28TQ(config)# ip pim bsr-candidate interface vlan 2 hash-
mask-length 10 priority 20

ip pim rp-candidate interface

Description
The ip pim rp-candidate command is used to configure the candidate RP on
specific interface. To disable the candidate RP on this interface, please use no
ip pim rp-candidate command.
Syntax
ip pim rp-candidate interface { { fastEthernet | gigabitEthernet |
ten-gigabitEthernet } port | loopback id | vlan vlan-id } [ priority pri ] [ interval
interval ]
no ip pim rp-candidate interface { { fastEthernet | gigabitEthernet |
ten-gigabitEthernet } port | loopback id | vlan vlan-id }
Parameter
fastEthernet | gigabitEthernet | ten-gigabitEthernet —— The port type of the
interface.
port —— The port number.
id —— The interface loopback ID.
vlan-id —— The interface VLAN ID.
pri —— The priority of the RP, ranging from 0 to 255.
interval —— The interval of RP advertisement interval. It ranges from 1 to 255
seconds.
Command Mode
Global Configuration Mode
Example
Configure the candidate RP on interface VLAN 2 with the priority as 20 and the
interval of RP advertisement interval as 70s:
T3700G-28TQ(config)# ip pim rp-candidate interface vlan 2 priority 20
interval 70
324