Mac Address-Table Max-Mac-Count - TP-Link JetStream T3700G-28TQ Reference Manual

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
Syntax
mac address-table filtering mac-addr vid vid
no mac address-table filtering { [mac-addr] [vid vid] }
Parameter
mac-addr —— The MAC address to be filtered.
vid —— The corresponding VLAN ID of the MAC address. It ranges from 1 to
4094.
Command Mode
Global Configuration Mode
Example
Add a filtering address entry of which VLAN ID is 1 and MAC address is
00:1e:4b:04:01:5d:
T3700G-28TQ(config)#mac address-table filtering 00:1e:4b:04:01:5d vid 1

mac address-table max-mac-count

Description
The mac address-table max-mac-count command is used to configure the
Port Security. To return to the default configurations, please use no mac
address-table max-mac-count command. Port Security is to protect the switch
from the malicious MAC address attack by limiting the maximum number of the
MAC addresses that can be learned on the port. The port with Port Security
feature enabled will learned the MAC address dynamically. When the learned
MAC address number reaches the maximum, the port will stop learning.
Therefore, the other devices with the MAC address unlearned can not access to
the network via this port.
Syntax
mac address-table max-mac-count { [max-number num] [mode { dynamic |
static | permanent } ] [ status { disable | enable } ] }
no mac address-table max-mac-count [ max-number | mode | status ]
Parameter
num —— The maximum number of MAC addresses that can be learned on the
port. It ranges from 0 to 1024. By default this value is 1024.
129